Intermediate frequency kHz Power requirement 4. Memorize the position and operation of each switch and control. In the following descriptions, all the servo reversing switches are assumed to be in the normal position. When they are in the reverse position, operation is the opposite of that described. Page 3 Neck strap bracket Bracket for neck strap.
Neck strap is sold separately. Antenna Strong telescoping antenna. Extend it to its full length when using the transmitter. Handle Use this bar to carry the transmitter. Nonslip adjustable lever head The length of the lever head can be adjusted to suit the operator. Lever head Lever head Unlock lever heads and , by turning them in the arrow direction, and adjust the head to the most comfortable length, then lock it by turning it in the direction opposite the arrows.
Rudder servo reversing switch Throttle servo reversing switch Fig. Transmitter crystal Battery cover Aileron servo reversing switch Charging of transmitter and receiver Nicad batteries Recharge the receiver and transmitter Nicad batteries as shown in Fig. If the direction of operation of the stick lever and the direction of operation of a servo are opposite, switch the appropriate servo reversing switch.
LED When these screws are removed, the back cover can be removed. Charging plug for transmitter. Set the springs for the best stick feel. Connect the Rx-connector of the dual charger to the receiver Nicad battery plug, and AC-plug the dual charger to AC-outtet socket as shown in the figure. When the set is not in use for some time, repeat discharge and charge two to three times before use. If the batteries are not used for a long time, their capacity will go down.
The power switch may be damaged if the battery connector is strongly pulled. In case of glider, two servos are supplied as standard. Receiver, servos, switches, and battery holder connections SSW-J Power switch Charging plug Aileron servo Elevator servo Extension cord In case of glider Throttle servo In case of engine powered plane The parts enclosed by the dotted lines must be purchased separately.
Pay careful attention to the polarity of the connector. Rudder servo Antenna wire Fig. Always use a noise killer capacitor on the electric motor. When using a class, etc.
The idle point trimmer sets the drive motor idling point. Starting the drive motor suddenly is dangerous. Unit has been fully tested without issue. See all 9 pre-owned listings. Sold by raynii About this product Product Identifiers Brand. Show More Show Less. Pre-owned Pre-owned. See all 9 - All listings for this product. Ratings and Reviews Write a review. Most relevant reviews. Great Retro Controller Works great and brings back memories of flying with antennas extended not like today with all the new technology.
Remote controller for boat Its great and what i was looking for but i wish it had a charger that went with it. Traxxas Stability Management TQi 2. Forgot password? Enter your email address and check your inbox. Please check your email for further instructions. Enter a new password. Please read this manual before using your new set. Neck strap. Frequency flag, Spare horn. You can only view or download manuals with.
Sign Up and get 5 for free. Upload your files to the site. You get 1 for each file you add. Get 1 for every time someone downloads your manual. Buy as many as you need.
0コメント