Manual termostato stc-1000

F4 sirve para calibrar la sonda. En mi caso es para controlar solamente unos ventiladores. Solo tendria q configurar la parte de enfriar no?

Siempre que tengo que configurarlo tengo que venir a este blog a mirar como se hace. Gracias por esta completa y concisa guia. Quiero programar una encubadora la temperatura ideal es de Name required. Mail will not be published required. Termostato STC El STC es un termostato simple, bastante extendido en el mundo de los terrarios y acuarios por ser de bajo coste.

No necesita transformador. Hay que conectarlo a los conectores 1 y 2 que aparecen en la pegatina del termostato. When the temperature is higher than or equal to 30 degrees, pick up the relay again, to start the output.

For example: When we measure the probe temperature was 25 degrees,it displays 25 degrees as the CA is 0, it displays 26 degrees as the CA is 1, it displays 24 degrees as the CA is This function is generally applied when the probe can not measure directly the measured object. For example, we place the probe at the outside of a cup to measure its water temperature, we need to adjust the CA parameters because of the heat loss of the cup, so that the display temperature can be in accordance with cup temperature.

The delay time is started to calculate from stopping the machine. The delay time of heating mode is as same as the cooling mode. If the set point outside this range, it needs to firstly change the value of HS and LS, then it can be achieved. HS means upper limit. LS means lower limit. For example: the upper and lower limits are used to limit the range of control temperature that can be set, such as: LS is 10, HS 20, then press the SET key to adjust the temperature control, it can only be varied between 10 and Turns out my wiring was off a touch, forgot to splice the neutral lead…or whatever.

Also, the instructions that came with my device were in broken english, at best. This gave me the answer to all the questions I had. I ordered two of the atcs and plan on using them to start the circulaters on my sloar colectores.

Just confused on the high low limit range. I would like to set it up to start at and shut off at Unless you are talking Fahrenheit you can not use it. If however, your range is in Fahrenheit degrees, you can. Hi really good to get this info but Im confused as to why the picture with coloured wires appears to be in reverse to the wiring diagram neutral appears in revers positions. It matters not. The picture shows mains operated model. It has a small transformer built in to provide the power to the unit, so it makes no difference, neutral and phase can be transposed.

Did you manage to come right? I have tried several times. Do you know is it possible to use the existing temp probe? Hi I have a v 1-pahse electric motor running a chiller compressor Sanden with 12v magnetic clutch.